Description
PREPARATION OF THE SUPPORT:
SIMBOLO can be applied to surfaces of different nature.
New plasters:
Make sure the plaster is dry and hardened properly (at least four weeks).
If necessary, reinforce with appropriate products.
In the presence of mold or algae, treat the surface with appropriate biocides.
Apply a layer of water-based fixative sealant.
Old plasters:
If the old paint is not perfectly anchored, it must be removed mechanically.
Any defects must be filled.
In the presence of mold or algae, treat the surface with appropriate biocides.
Applied a possible layer of water-based fixative sealant.
The high coverage of the product allows application without the use of a base paint. However, it is recommended to standardize the absorption of the surface.
To obtain an optimal result, it is recommended to apply on smooth or smooth surfaces.
APPLICATION PROCEDURE:
SIMBOLO can be applied in different ways to achieve different effects.
- EXTENDED EFFECT:
Apply a layer of SIMBOLO with a brush or other similar tool, following the movement of the stripes (horizontal or vertical). When the product is almost completely dry, go over the surface with the plastic spatula to create the broken effect. During the drying phase, the product tends to develop color. - DIAGONAL EFFECT:
Apply a layer of SIMBOLO with a brush or other similar tool, following the diagonal movement. When the product is still wet, go over the surface with the plastic spatula to create the effect of three-dimensional movement. Passing over the spatula several times, the colors mix, producing the characteristic multicolored effect.
During the drying phase, the product tends to develop color.
If necessary, retouch the surface with the spatula, taking care to deposit a little fresh product on it. - HUMAN APPEARANCE:
Apply a layer of SIMBOLO with a brush or other similar tool, following the movement of the stripes (horizontal or vertical). When the product is still wet, go over the surface with the plastic spatula to create the striped effect. Passing over the spatula several times, the colors mix, producing the characteristic multicolored effect.
During the drying phase, the product tends to develop color.
If necessary, retouch the surface with the spatula, taking care to apply a little fresh product on it.
PHYSICAL-CHEMICAL PROPERTIES:
- Dilution: none. Product ready to use
- Specific gravity: 1.43 ± 0.05 gr/ml
- Yield (indicative): 4-6 m2/l depending on the roughness of the surface.
- TVOC: Class A+
CLIMATE CONDITIONS OF APPLICATION:
• T = + 5 / + 30 ° C; RH not higher than 75%.
• Do not apply on hot surfaces or in any case with T> 30°C.
• Tools: brush and plastic spatula
• Tools must be washed with water after use
IMPORTANT!
Mix by hand to avoid damaging the components. Avoid using mechanical stirring and/or mixing systems. Do not apply on hot surfaces or in any case with T> 30°C.
HANDLING – STABILITY:
Storage: in environments with temperatures between 5 and 35°C.
SIMBOLO is stored in a dry place, at room temperature and in sealed containers, it does not present stability problems. The maximum recommended storage time is 12 months. Regarding the evaluation of toxicological data, please consult the safety data sheet.
The product does not withstand freezing.
Liability note:
The advice and indications in this technical sheet are given based on our experience, but we cannot engage in responsibility.
Our technical service is available to provide any additional information required.
Reviews
There are no reviews yet.